Wacom GRAPHIRE CTE-630BT User Manual download pdf (Page 46)

Index

Contents

Index

Contents

TESTING YOUR TOOLS

If your tool does not work as you expect, it is a good idea to ﬁrst check the assigned functions or to reset the

tool to its default condition using the Pen Tablet control panel.

1. Check the pen.

• Move your pen across the active area of the tablet; the screen cursor should move in the

corresponding direction on your display screen.

• Press the pen tip against the surface of the tablet. The power indicator light should turn from blue to

green.

• Next, without applying pressure to the pen tip, hold the pen tip within approximately 5 mm (0.20 inch)

above the tablet surface and press the side switch. The power indicator light should again change

from blue to green.

• Turn the pen over and press the eraser against the surface of the tablet; the power indicator light

should change from blue to green.

• If not, you may have a defective pen or tablet. See t

echnical support options.

2. Check the cordless mouse.

• Move the cordless mouse across the active area of the tablet; the screen cursor should move in the

corresponding direction on your display.

• Test the buttons on your cordless mouse by clicking each button. The tablet power indicator light

should turn green when a button is pressed.

• If not, you may have a defective cordless mouse or tablet. See t

echnical support options.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 73 74

No comments

Wacom GRAPHIRE CTE-630BT User Manual Page 46