Wacom CTF-220 User Manual download pdf (Page 60)

XT[2] Series DISK RECORDER

Version 10.04 - Hardware

Technical Reference Manual

Issue

10.04.A

EVS Broadcast Equipment

–

January 2011

if check is successful:

LED 3 on (green)

Polling for PC

commands

LED 4 on (green)

Switching to enhanced

mode

LED 5 on (green)

Executing PC

commands until

execution requests end

LED 6 on (green)

Jump to SDRAM and execute microcode

CONNECTORS

On the XNet[2] module (SDTI) :

J3: Not used

J4: Not used

J5: OUT connector for XNet[2] (SDTI network 540/1485Mbps without

relay)

J6: IN connector for XNet[2] (SDTI network 540/1485Mbps without relay)

Note

J5 must be used with J6. Never use J3 with J5 or J4 with J6.

GIGABIT CONNECTORS

The two Gigabit connectors of the card are connected to the two Gigabit ports of

the backplane.

The Gigabit connectors must be on a network that supports Jumbo Frames of (at

least) 9014 bytes Ethernet frames. One of the tested switch belongs to the Cisco

3750 G family, for example the WS-C3750G-24T-S.

For more information, refer to the Multicam Configuration manual for setting up

the IP addresses.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 69 70

No comments

Wacom CTF-220 User Manual Page 60