Wacom CTF-220 User Manual download pdf (Page 67)

Issue

10.04.A

XT[2] Series DISK RECORDER

–

Version 10.04 - Hardware Technical Reference

EVS Broadcast Equipment

–

January 2011

Connectors

OUT2 SD The OUT SD connector of the multiviewer board is

connected to the MULTIVIEWER SD SDI connector on the

rear panel of the server.

DB15 The DB15 connector of the multiviewer board is

connected to the MULTI DB15 connector on the rear panel

of the server.

LED INFORMATION:

Internal EVS information

BOARD CONFIGURATION:

HPOL, VPOL and ENVS are used to configure the composite sync generator used

in LSM TV mode (no effect if LSM is only used with a VGA monitor).

The HPOL jumper can be used to invert or not the VGA HS signal (Horizontal

Sync) to generate the composite output signal (TV mode)

The VPOL jumper can be used to invert or not the VGA VS signal (Vertical Sync)

to generate the composite output signal (TV mode)

The ENVS jumper can be used to enable or not the presence of the VGA VS signal

(Vertical Sync) in the composite output signal (TV mode)

If the LSM TV mode is used, these jumpers must be set-up according to EVS

recommendations, which depend on LSM software version and CPU board

model/revision:

With MPTC board A2/A3 or A2/A4, set up the jumpers as follows:

• HPOL=On; VPOL=Off; ENVS=On

REMOTE RESET jumpers are available to designate the remote(s)

from which the RESET command can be sent.

This command resets the whole system: PC and video hardware.

In standard configuration only Remote one (on RS422 port 1) is

allowed to reset the system.

Important

This jumper should be removed if the device connected to the RS422

port is NOT an EVS controller. Maximum voltage on pin 5 of an RS422

port of the XT server should not exceed 5 Volt when the corresponding

jumper is engaged. Applying a higher voltage on pin 5 when the

corresponding jumper is engaged will result in permanent electronic

damage to the board.

1 2 ... 62 63 64 65 66 67 68 69 70

No comments

Wacom CTF-220 User Manual Page 67