Wacom Cintiq 20WSX Installation Guide download pdf (Page 38)

Customizing

Page 36

Adjusting the LCD monitor

Factory presets, auto-sync, and user settings

Factory presets: For optimal display quality, set your video card to Cintiq’s native resolution of

1680 x 1050 pixels (WSXGA). See page 62 for signal speciﬁcations.

Auto-sync: When connected as a VGA display, Cintiq attempts to automatically synchronize to the

incoming signal. At the native resolution of 1680 x 1050, the vertical refresh frequency must be set

to 60 Hz. For other resolutions, auto-sync will function when the horizontal frequency is between 30 to

82 kHz and the vertical frequency is between 50 to 75 Hz. If a speciﬁc resolution and vertical refresh

frequency are not supported, you will see an “out of scan range” message. In this case choose a

different resolution or refresh frequency. The auto-sync function automatically sets the horizontal and

vertical screen position, as well as pitch and phase.

If Cintiq does not automatically synchronize with the incoming signal, you can open the OSD

menu, go to the RESET menu, and select the AUTO ADJUST option to initiate display synchronization.

Additional screen display adjustments can be manually made using the OSD controls.

Color calibration: Changing the color, color temperature, contrast, brightness, or backlight from their

default settings will invalidate the ICC color proﬁle that was included on the driver CD.

Working with on screen display settings

Cintiq is equipped with an On Screen Display (OSD) function. The OSD function enables you to adjust

and optimize a variety of display settings at the touch of a button. The OSD controls are located on the

back of the unit. Simply reach over the top of the display unit to locate the buttons with your ﬁngers.

Note: Braille-style dots above the buttons help you to identify each one by touch.

MENU button

Use this button to open

or close the OSD menu.

Selection buttons

Use these buttons to select an option that can then be

activated when you press the E

NTER button.

After activating a selected option, press the up button

to increase a selected item value, and press the down

button to decrease it.

Digital/Analog (DVI/VGA) switch

(up) (down)

NTER button

Activates or deactivates the

selected OSD menu option.

Cintiq20WSX_Manual.fm Page 36 Monday, January 15, 2007 9:23 AM

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 71 72

No comments

Wacom Cintiq 20WSX Installation Guide Page 38